All Categories
Featured
Table of Contents
That window can transmit more solar heat in winter than in summer season. A west-facing window on a summertime's afternoon has an angle of incidence from near 0 as much as 30 with a large reliable area of solar radiation. A north-facing window, in summer, has a high angle of incidence and a low reliable area of solar radiation, so can transfer less heat than a west-facing one.
You can rapidly and quickly enhance the thermal efficiency of your home by changing your windows. There are thousands of types of glass and frames to select from.
Single glazing with clear glass is not very efficient when it comes to heat loss or gain. To improve efficiency, you can use single glazing with a more energy-efficient type of glass such as low emissivity (low-e) glass.
Multiple layers can be put together with sealed cavities between each sheet of glass. IGUs normally offer much better energy efficiency than single glazing, since they send less energy. The energy efficiency of IGUs also depends on: the homes of each layer of glass. Various glass types (for instance, clear and low-e glass) can be put together in an IGU.
IGU cavities can be filled with air or a more inert, low-conductivity gas such as argon the width of the cavity. Cavity thickness is typically 6 to 18mm. Wider cavities provide lower (much better) U worths, with 12mm usually accepted as the preferred space how well the cavity is sealed. Cavities should be dry and well sealed to avoid moisture getting in.
If argon is set up to the cavity in place of air, moisture is reliably excluded the level of desiccant (drying representative). The spacer (metal or polymer strip) that separates the glass layers contains a desiccant to take in any moisture. Inadequate desiccant might cause moisture to condense on the glass surface in cold conditions, decreasing thermal efficiency.
IGUs can provide better energy performance for all environments, particularly in heated and air-conditioned homes. Cross-section detail of single, double and triple-glazing units Low emissivity glass (typically called low-e glass) lowers heat transfer. Low-e glass may be either high or low transmission: High transmission low-e glass has a finishing that permits daylight from the sun to enter your home to attain great solar heat gain, but decreases the amount of the long wavelength infrared heat that can escape back through the window.
Low-e glass has either a pyrolytic finishing or a vacuum-deposited thin movie metal finishing. Pyrolytic coverings are long lasting and can be used for any glazing; vacuum-deposited coverings are soft and are just utilized within IGUs. Low-e coverings can considerably improve both U worth and SHGC; however, they need to be used correctly or they will either degrade or fail to perform as needed.
Low-e finishings can be used in combination with clear, toned or reflective glass. Low-e finishes on glazing can lower heat transfer where required Picture: Department of Market, Science, Energy and Resources Toned glass has actually colouring additives included during manufacture. It is readily available in various colours, usually bronze, grey, blue and green.
Latest Posts
Window Glazing For Households - Energy in Myaree WA
Why You Need Secondary Glazing In The Summer in Madeley WA
Secondary Glazing: Is It Worth It? in Applecross Perth